Some work on the car has gotten done over the last few days, but I've been too lazy to post or even take a picture.

I got the wiper switch installed under the dash. I wanted to drill a new hole in the dash, but I didn't have a drill bit big enough, and I was also worried about messing up the vinyl dash covering and drilling the hole off center. So, I just punted and installed it underneath. I had to fabricate an aluminum bracket for this, and remove the dash to install it.

I started to polish the stainless steel spacers that go over the bolt that attaches the quick jacks. As I polished each one, I got better and now have to go back to the first few I did and redo them. They turned out pretty good, and I'll take an updated picture of them on the car. I also test fitted the rubber grommets that cover the front quick jack body holes.