The blinkers and Hazards work! It turns out it was pretty simple. There was a place on the fuse box that really wasn't labeled that need a fuse. It was the fuse the gave the wire going to the turn signal switch juice. After that was hooked up, we got turn signals. Now, there still is some work to be done, the lights supplied with the kit have a dim and bright setting (dim for parking lights and bright for turn signal/brake light). Of course, the color of the dim and bright wires were not always the same, even though I wired them up that way. So, I need to switch a bunch of wires around on 3 of the lights. Also, the diodes I used for the single turn signal light thing, worked great. However, I need to do the same for the hazards. With the hazard wires hooked up, if you turn on the left or right turn signal all 4 lights will blink. This is because the output of the hazard switch is spliced into both left and right turn signal lights. If one turn signal light is turned on, the power goes to the hazard switch post that is also going to the other turn signal wires.